Onshape CAD Specialist for Wearable Device

About the project

Here's a job post ready to copy onto Freelancer.com: Title: Onshape CAD Modeler Needed — Wearable Device + Charging Dock (2 Assemblies, 48hr Turnaround) Description: I need an experienced Onshape modeler to build a complete CAD package for a wearable posture sensor device and its matching USB-C charging dock. Full spec and dimensions are provided in an attached build guide — this is a modeling job, not a design-from-scratch job, so someone comfortable following detailed specs will move fast. Scope: Assembly 1 – PRS Device (4 parts): Top enclosure (domed, snap-fit slots, alignment holes, mounting boss) Bottom enclosure (curved ergonomic underside, battery channel, snap tabs, dock alignment features) 18650 battery (simple representative part) Draft electronics holder (block with contact bosses and mounting holes) Assembly 2 – Charging Dock (3 parts): Top enclosure/cradle (negative-fit geometry matching the device underside) Bottom enclosure (USB-C cutout, internal pocket) Draft electronics block Deliverables: Onshape document link (2 Part Studios, 2 Assemblies, fully mated, zero interference) Exploded + assembled views for both assemblies One PDF exported from Onshape with all views Requirements: Must use cantilever snap-fit joining (dimensions provided in spec) Realistic clearances around the 18650 cell Clean parting lines, proper shelling, no interference on assembly Timeline: 48 hours from award Budget: Negotiable Full written spec + dimension tables will be sent immediately on hire. Looking for someone who's used Onshape assemblies and shell/sweep features before — please share a relevant past project in your bid. Want me to plug in a specific budget number, or are you posting it open for bids first?

Skills required