KiCad High-Frequency RF PCB Layout
USD 250–750
About the project
I need a complete high-frequency RF PCB laid out in KiCad for a signal-processing application. The board must integrate antennas directly on the substrate; no filters or discrete amplifiers are planned at this stage, so every trace, via, and ground return has to be optimized for clean, low-loss feed to the antenna structure. Scope • Translate my existing schematic (KiCad format) into a production-ready multilayer layout. • Model and route all RF paths with controlled impedance, proper stack-up definition, and tight clearance to meet high-frequency performance targets. • Design and tune the on-board antenna geometry, matching network, and keep-out regions inside KiCad’s PCB editor and 3D viewer. • Run DRC, ERC, and any KiCad integrated RF simulation tools you prefer, then iterate with me until we meet the S-parameters I will supply. Deliverables • KiCad project folder: schematic, PCB file, custom footprints, and 3D models • Gerber, drill, and assembly files ready for fabrication • A brief layout report outlining impedance calculations, antenna tuning steps, and key design rules applied Acceptance The board should achieve the target return loss and bandwidth figures I will provide after we begin. All files must open without errors in KiCad 7.
Skills required
This job is listed on Freelancer.com. AiZity aggregates listings for discovery only and is not the employer. To bid or apply, use the button in the sidebar.