3D-Print Logo Keychain w/ NFC
USD 10–30
About the project
I have a clean logo file that I’d like transformed into a small plastic key-chain. My plan is to 3D print it on an FDM printer and pause the print at the correct layer so I can drop in the NFC sticker I already have on hand, then let the print finish and seal it inside. Here’s what I need from you: • A printable 3D design based on my logo that looks good at key-chain size and leaves a neat recess for a standard round NFC coin (25 mm diameter, 1 mm thick). • The finished STL plus a ready-to-run G-code file (PrusaSlicer or Cura is fine) with a programmed pause at the exact layer where the recess starts. • A quick note in the file or message stating the layer height and the precise layer number so I can pause manually if needed. Dimension guidance, filament type, or any other details you need—just let me know once you see the logo. I’ll approve the final model by test-slicing it on my end before we wrap up.
Skills required
This job is listed on Freelancer.com. AiZity aggregates listings for discovery only and is not the employer. To bid or apply, use the button in the sidebar.