Custom Plywood Sub Box Design
USD 10–30
About the project
I have the subwoofers and the vehicle ready—I now need a fully-detailed design for the enclosure. The box will be built from plywood and finished with a carpet wrap, so the drawings must account for board thickness, bracing, and any edge radiuses that might telegraph through the carpet once it’s stretched and glued. I haven’t settled on the acoustic style yet; I’m open to a well-tuned ported/vented, a compact sealed, or even a bandpass layout if it genuinely suits the drivers’ specs. Your design should therefore start with a quick modelling pass (WinISD, BassBox, or similar) to confirm air-space and tuning before you lock in the cut list. Deliverables I expect: • A dimensioned 2D cut sheet showing every panel, brace, and port piece • A clean 3D model (SketchUp, Fusion 360, or comparable) that I can rotate and measure • A brief spec sheet summarising internal volume, tuning frequency, port area/length (if used), and expected F3 2× Pioneer IMPP 450W 12-inch round subwoofers 1× Bazooka TAV141 10-inch triangular subwoofer
Skills required
This job is listed on Freelancer.com. AiZity aggregates listings for discovery only and is not the employer. To bid or apply, use the button in the sidebar.